1.run swan software

2.operation according to the number sequence

1.selec systemt->2.select Demo mode ->3.check Super Demo ->4.click Tryit(probation)

 3.following interface displays

note：
1.if serial number dose not display in following dialog box, please install TCP/IP and NWLink NetBios protocol in attribute of network neighbor.

4.please send the serial number through the following methods and ask the master of QQ group for register number or leave your message:

5.please fill the register number into "Register" dialog box after you get specifiedd register number.then click “OK”.

6.loging system is successful.

notice:when enter Fanuc 0MD system, the prompting dialog box is unuseful.Here,system closing after 5 minutes is canceled.